From top to bottom, left to right, front to back, it's worth measuring a couple of times for accuracy. Remember that homes settle and what one measurement is doesn't necessarily mean that it will be the same measurement on the opposite side.
When it comes to the door opening of a new refrigerator, you need to think about how far the door will open and fill the space of your kitchen. Many refrigerators need to be open to 90 degrees or more to allow full access to vegetable and door bins. If space is a concern, be sure to review the installation instructions and specification sheets prior to your purchase. If there's not about 2-inches of space on the hinge side, then you'll have to keep in mind that the refrigerator will need to be pulled out about 2-inches to make up for this.
Refrigerators need to breathe. If they are entirely boxed in, then there's not much room for ventilation. The big consideration is the space required around the unit for proper ventilation of the compressor. Built-in and integrated refrigeration have a dedicated open space with a grill built into the unit that allows for proper cooling of the compressor. However, with standard and counter depth units , you still need the compressors to breathe from the bottom of the refrigerator.
If the refrigerator is too tight, the heat will seize the compressor. Rear: You should leave a minimum of 1-inch, and preferably 2-inch of clearance. Typically, because of the electrical or water connection, this will help push the fridge out slightly away from the wall, but Inches is ideal. In the past, refrigerator coils were usually on the rear of the units, which helped push it away from the wall and allowed the heat to dissipate properly.
Now the coils and components are located below the units. Ideally, if the fridge has proper spacing the grill below the unit will pull in cooler air as the coils and components heat up. The warm air will travel behind the rear of the fridge and dissipate through the top channel.
This keeps the coils and components cool, so they do not overheat. A fridge without proper ventilation will show specific symptoms, some right away, and some over the course of a few years. If the compressor runs at an above average temperature for a prolonged period or is unable to properly cool down you may see the following issues: Poor cooling, unusually loud compressor noise and vibrations, an increase in electricity bills, and compressor or condenser issues including component failure unusually early.
You should take all these dimensions and factors into consideration when measuring for your new refrigerator. It is better to err on the smaller side and leave additional space for the unit to cool rather than trying to fit in the biggest unit for the space.
You can prolong the life of your refrigerator. An ideal temperature for a fridge to operate at its most efficient state is between degrees. Note that if you plan on putting a backup fridge in the garage, oftentimes the temperature swing is far outside of the maximum range of degrees especially in winter.
You can buy special refrigerators for this application. Low humidity typically would not be a cause for concern. How much clearance does a door need? Following Standard Guidelines. How much clearance does a freezer need? How far should a fridge stick out past the counter? Do fridge freezers need ventilation? What can you store on top of the fridge? What are the sizes of refrigerators? How wide should a refrigerator opening be?
Can you put a refrigerator in a closet? Can freestanding refrigerator be built in? Where should refrigerator be placed? Can a fridge go next to an oven? Your fridge and ovens can be closer than you think. What size is under counter fridge? Will a refrigerator fit through a door? How much space is needed between refrigerator and dishwasher? Do French door refrigerators have more space? French Door vs Side by Side Refrigerators.
What is the difference between standard depth and counter depth refrigerator? Can you put a refrigerator against a wall?
0コメント